News & events

Fresh news from CABERG

Helmets

PINLOCK AND FOG CITY GO INSERT LENSES ENSURE OPTIMAL VISIBILITY ALSO IN THE WINTERTIME

PINLOCK AND FOG CITY GO INSERT LENSES ENSURE OPTIMAL VISIBILITY ALSO IN THE WINTERTIME

In the wintertime, during cold and rainy weather conditions, the visor tends to fog up compromising the visibility and the rider’s safety. Even though on the market there are plenty of anti-fogging sprays, they cannot grant a definitive and long-lasting solution to a problem that can seriously affect our safety and those around us.  

Looking for the best solution? Then you must try Pinlock and Fog City Go lenses

Most of you are already familiar with these lenses because they became an essential accessory to prevent visor from fogging up during cold and rainy conditions, but also during abrupt change in temperature when entering a tunnel.
 

PINLOCK and FOG CITY GO: YOUR BEST SAFETY ALLIES!

Pinlock and Fog City Go are transparent insert lenses made from a moisture-absorbing material with a silicone seal that is secured to the internal side of the visor with pins to create an ‘air-tight’ chamber in order to prevent the visor from fogging or misting.

 

CABERG HELMETS ARE READY FOR PINLOCK AND FOG CITY GO LENSES

Quite some Caberg helmets come with the Pinlock and/or Fog City Go lens already in the box while other models have the Pinlock ready visor. If you’d like to learn more about our models and the anti-fog lens you can visit our website: https://www.caberg.it/en/ . What’s more, you can see the complete list of our visors at: https://www.caberg.it/en/visors/

 

HOW TO INSTALL AN ANTI-FOG INSERT LENS

Although Pinlock and Fog City Go lenses are very popular, there are still many motorcyclists who do not use them because they fear to damage the visor when installing. No worries, today we’ll explain step by step how to install the insert properly and very easily just by following our instructions and the tutorial video! We remind you that all anti-fog lenses offered by Caberg come with the installation instruction in the package.

First of all, it is necessary to take the visor off the helmet according to the instruction manual. As next simple step, we suggest you to clean the internal part of the visor with water and mild soap and dry it using a non-abrasive cloth in order to avoid the chances of scratching the surface of your visor. Both ends of the visor have a pin, this is where the Pinlock or Fog City Go lens needs to be fitted.  

The anti-fog lens on one side has the silicon edge that will be placed against the internal side of the helmet visor while on the other one there is a removable yellow protective film. At this stage, slightly and gently bend the visor flat and then fit in the Pinlock or Fog City Go lens.

Check if it is pressing against the visor everywhere and it’s done!

In case the insert is not tightly pressed up against the helmet visor or either is too short or too loose, you can easily turn the eccentric pins to adjust the distance between them. After this step, it is possible to remove the yellow protective film from the lens and then re-install the visor onto your helmet. 

It wasn’t that difficult! Now you are ready to leave and enjoy your next journey safely!

Scroll to Top
This site uses cookies, also third parties, to customise your browsing experience and send you services in line with your preferences. For additional information or to deny your consent to all or some cookies, click here. By continuing browsing, you accept the use of cookies.
Ok, I understood